2. Press and hold the device key you want to program. The POWER key
illuminates.
While you’re holding down the device key, use your other hand to press and
hold the remote’s POWER key at the same time. The POWER key turns off.
3. Wait until the remote’s POWER key comes on and stays on. Then release
both keys.
4.
Point the remote directly at the front panel of the device you want to
control. Press POWER on the remote and wait 2 seconds
.
The remote is
testing a single code for your device.
Did your device turn off?
YES: Press the STOP key to store the code. You’re done! You’ve
programmed this device key.
To Next Page
Loading...
Need help?
General
