NO: Press POWER again. The remote tests the next code
. Keep pressing
POWER every 2 seconds until your device turns off. When it does press
STOP.
NOTES: Throughout the programming of each key, keep the remote pointed at the IR
sensor of the device you are programming the remote to control.
Test the remote with the device to make sure the device key is programmed with the
correct code for maximum functionality. If some features don’t work, try a different code.
See the “Testing the Code for Maximum Functionality” section below for more
information.
During the Manual Code Search, the remote ignores keypresses that aren’t part of the
search. The search times out after two minutes (the POWER key blinks four times and
turns off, and the last programmed code under that device key is retained).
The POWER key blinks four times and turns off when the remote has gone through all
the codes. The remote exits the Brand Code Search. If your device hasn’t turned off
yet, try a different search method.
TIPS: because there are so many codes, you may have to press the POWER key
many times—possibly hundreds of times.
To Next Page
Loading...
Need help?
General
