EN
6
Operating the Clock
Turning off Alarm
Silence the alarm momentarily
Press SNOOZE. The alarm will sound again
when the snooze period is over. (see
“Snooze Alarm Operation”).
Stop the alarm
Press OFF. Then the alarm will be on the
following day at the same time.
Disable the alarm permanently
1. Press CANCEL button.
2. The WAKE 1 and WAKE 2 indicator will
be flashing.
3. Press WAKE 1 or WAKE 2 button within
3 seconds to deactivate the alarm function
permanently, “OFF” will be shown when
the above procedures are done.
Tip: You can activate the previously
set alarm time by pressing
WAKE 1 WAKE 1
WAKE 1 WAKE 1
WAKE 1 or
WAKE 2WAKE 2
WAKE 2WAKE 2
WAKE 2 button.
Snooze Alarm Operation
This operation allows extra sleep time af-
ter the alarm is on. The alarm will be off
by pressing SNOOZE until the snooze pe-
riod is over, the default SNOOZE period is
9 minutes.
Seconds Time Display
The unit may display in seconds.
1. The clock should be in normal mode.
2. Press and hold SNOOZE to show sec-
onds display.
3. Release SNOOZE to return to the hour
and minute display.
Changing the lens
The unit has three different lens provided:
blue, green and gray. You may change your
favourite colour with the hexagon key
(size: 3/32” ) located at the buttom of the
unit.
Brightness control
You can adjust the back-
light by the DIMMER but-
ton, there are three modes
you may select from:
AUTO - Backlight on for a
few seconds whenever a
button is pressed.
HIGH - Backlight always
high.
LOW - Backlight always
low.
DIMMER
Hi
Lo
AUTO
RP3722 EN-CAN 3/8/02, 3:57 PM7
To Next Page
Loading...
Need help?
General
