CD Display Messages
When using the CD function, you may encounter the following messages:
i-_ NCC
L L U J L
CD compartment tray is in.
I_ I
riPE,,,
U CD compartment tray is out.
I_ I 17 TI I_"_ I_ No disc is loaded onto the CD compartment tray.
Ill LI _1 _1 I_
E! p.u
Ii J _1
No tracks are programmed (applies to both Program and ATS mode).
ill I
UL L
Program is full (applies to both Program and ATS mode).
P E rq_,,
Reading disc's table of contents (how many tracks there are and the
total time for the disc). This information is displayed when the unit is
in Stop mode.
I-- I I TI I-- I--
L 17 _1 7 L Discchangein process.
T "El TI I I Unit isin Standbymode
m Zl £1 "-I
ERROR
II Obstruction to the opening and/or closing of CD compartment tray. (
Prevent obstruction and press OPEN/CLOSE to close tray.)
irl i i i- I-
II u J r..-
Sound output of the unit is temporarily suspended. ( PressMUTE on
the remote control to cancel Mute. )
0 .................................... "
RP8075RS IB 11 7/20100, 5:02 PM
To Next Page
Loading...
Need help?
General
