11
EN
Selecting Tuner Band
1. Press SOURCE repeatedly to enter Tuner mode.
2. Press BAND to select between FM or AM
radio band.
Tuning to a Station
Press or to select frequencies.
Using Presets
Press BACK/SELECT on the main unit or or
on the remote control to access the
previous or next preset station. The PROG icon
lights up
when a preset station is selected.
The display first shows the preset program
number and after a few seconds, the frequency
will be displayed.
(PR:01 is FM preset 1)
Auto Preset Programming
(FM only)
Press and hold the BAND button for 2 seconds to
scan stations in FM band. The stations will then
be stored as preset channels. A maximum of 32
stations can be stored. Beware of your preset
channels being erased accidentally because the
scanning and storing process is automatic upon
pressing the button. You can stop the automatic
scan by pressing any button, but the erased
stations cannot be recovered.
Manually Setting Presets
1. Press or to access the desired
frequency.
2. Press the PROG button once.
3. The most recently accessed program location
will be displayed.
4. If a different program location is preferred,
press / on the remote control to move
to the desired preset number (1-32).
5. Press PROG to store the selected
frequency at that preset.
Suppressing Stereo Signal
Press FM ST to toggle between FM mono and
stereo mode (remote control only). “STEREO” is
displayed in stereo mode.
Tips:
Your audio system has 32 preset
stations.
Radio
To Next Page
Loading...
Need help?
General
