12
EN
Recording
Recording CD to USB device
1. Connect the USB device to the main unit.
2. In CD stop mode, CD navigation mode or CD
pause mode, press CD REC to start CD
playback and recording will begin
automatically. This is indicated by the REC
icon on the display.
3. Press CD REC or to stop recording.
Example
(To record only selected tracks from a CD):
1. Create a CD program(Refer to “Setting Up a
Program List” on page 15).
2. From normal playback mode, press PROG.
3. Press CD REC, playback and recording will
begin automatically. This is indicated by the
PROG and REC icon on the display.
4. Press CD REC or to stop recording.
Deleting Files from USB device
1. In navigation mode, select the file to delete
using the navigation buttons (Refer to
“Navigation Buttons” on page 6 for details.)
2. Press DEL on the remote control.
3. Press or on the main unit or press
or on the remote control to select Yes
to delete or No to cancel.
4. Press SELECT on the main unit or on the
remote control to confirm selection.
Deleting All Files
In navigation mode, press and hold DEL on the
remote control to delete all the files on the USB
device.
Note:
The encoding bitrate for CD is 128
kbps.
Tips:
If CD playback is already started or
paused, recording will start instantly from
the time point which is playing or paused
when CD REC is pressed.
Tips:
Recording stops automatically when
CD stops (e.g. end of disc is reached).
Tips:
Make sure “write protect” is turned off in
the USB device during recording.
To Next Page
Loading...
Need help?
General
