Operating your Receiver
EN
15
Using the receiver to play a source
After having properly connected a source (DVD, CD,
VCR) to the receiver, you can partly control them
through the receiver.
Playing a DVD with the receiver
1. Connect a DVD player to the receiver (see connecting
your receiver for details).
2. Press ON/STANDBY on the main unit or press
ON•OFF on the remote control to switch on the
receiver.
3. Press the SOURCE buttons on the main unit or
DVD•6 CH on the remote control to select the DVD
source.
4. Switch ON the DVD player and start playback.
5. Switch ON your TV.
6. Select the appropriate A/V channel on the TV (refer
to your TV manual for details) until the image from
the DVD player is displayed.
7. Set the sound Mode if needed (see "Advanced sound
control" for details).
Example 1:
To play Dolby Prologic II Movie sound
Press the SURROUND buttons until "Dolby PL II
MOVIE" appears on the Display and all of the
speaker'’ icons light up.
Example 2:
LD: You may need to select a different Audio Channel
on your LD (refer to your LD player manual).
8. Adjust the volume knob accordingly.
NOTE
To play Dolby Digital sound, the source must be
connected to the receiver via the optical or
coaxial terminal
NOTE
To receive VCR signal for recording, you must
connect analog output from DVD/CD/SAT/TV to
the analog input of the receiver.
To Next Page
Loading...
Need help?
General
