Operating your Receiver
Operating the Radio
The receiver has a built-in tuner that allows for AM/FM
radio function.
Manual tuning
1. Connect the FM and AM antenna accordingly (see
"Connecting the Antenna" on page 5 section for
details)
2. Press ON/STANDBY on the main unit or ON•OFF on
the remote control to switch on the receiver.
3. Press the SOURCE buttons on the main unit until the
tuner mode is selected or press TUNER on the remote
control.
4. To select between FM
and AM band, press the
TUNER button
repeatedly.
5. Tune to a station by
pressing TUNER - or
TUNER + repeatedly
until the desired station
is found.
Automatic Tuning
Press and hold TUNER - or
TUNER + for about one
second to activate the
automatic SEARCH function.
The receiver will
automatically tune
frequencies until it finds a
station.
Select a sound effect if needed by pressing the
SURROUND button. (see "Advance sound section" for
details).
Selecting Mono or Stereo Sound
Press the ST•MONO button
on the remote control to
toggle between mono and
stereo sound in FM tuner
mode (when available).
NOTE
1. If there is interference, move the location of
the antenna until the optimal sound is heard.
TV and other electronic devices could be the
cause of interferences so try to position the
antenna away from them.
2. Weak signal can affect the "auto Search
function". Adjust the antenna for better
reception and for a more efficient search.
16
To Next Page
Loading...
Need help?
General
