To Next Page

To Previous Page

WARNING: Never suspend 4PRO speakers by there handles. Handles are intended for transportation, not for

rigging.

PROTECTIONS

4PRO Series active speakers are equipped with a complete system of protection circuits. Two led on the amplifier

back panel indicate the working status of the amplifier: the green led indicate that the speaker is ON and the red

led is on when the protection circuit is active. The circuit is acting very gently on audio signal, controlling level and

maintaining distortion at acceptable level. If this led is ON for a long period is better to reduce immediately the

signal level from the mixer or from the speaker volume control.

VOLTAGE SETUP (RESERVED TO THE RCF SERVICE CENTRE)

230 Volt, 50 Hz SETUP : FUSE VALUE T10 AL 250V

115 Volt, 60 Hz SETUP : FUSE VALUE T5 AL 250V

Questions and Answers:

Need help?

Do you have a question about the RCF 4PRO Series and is the answer not in the manual?

RCF 4PRO Series Specifications

General