Need help?Do you have a question about the RCF ART 310-A and is the answer not in the manual?
General| Frequency Response | 50 Hz - 20 kHz |
|---|---|
| Max SPL | 127 dB |
| Woofer | 10" woofer |
| Input Connectors | XLR, Jack |
| Horizontal Coverage Angle | 90° |
| Output Connector | XLR |
| Crossover Frequency | 1.8 kHz |
| Amplifier Power | 300W (200W LF + 100W HF) |
| Vertical Coverage Angle | 60° |
| Type | Active 2-way speaker system |
| Dimensions (H x W x D) | 537 mm x 337 mm x 315 mm |
Details on woofer, voice coils, magnets, and compression drivers used in the ART Series.
Focus on TAED amplifier technology, monolithic modules, and input features.
Describes horn design, bass reflex cabinet material, and mounting points.
Explains risks of hearing loss from high sound levels and the need for hearing protection.
Control for adjusting input stage gain and sensitivity.
Switches input sensitivity between 0 dB line and -40 dB MIC.
Indicates power status and limiter activity to prevent clipping.
Describes balanced/unbalanced XLR inputs and XLR signal output for linking.
Connects power cord, contains fuse, and main power ON/OFF switch.
Allows changing supply voltage to 230V or 115V, requires fuse change.
Verifying voltage selector position before connecting the speaker.
Connecting cables and setting volume to minimum before powering on.
Describes speaker stand mounting and safe suspension procedures.
Explains amplifier protection circuits and status LEDs.
Information on voltage selection and fuse values, reserved for service.
To Next Page
