Need help?Do you have a question about the RCF ART 315-A MK III and is the answer not in the manual?
General| Woofer | 15" |
|---|---|
| Horizontal coverage angle | 90° |
| Vertical coverage angle | 60° |
| Crossover Frequency | 1.8 kHz |
| Output Connector | XLR |
| Input Connectors | XLR, Jack |
| Weight (Approximate) | 23 kg |
| Type | Active Speaker |
| Input Connector | XLR |
| Tweeter Size | 1" |
| Tweeter | 1" |
Lists the page number for the English language content.
Lists the page number for the Italian language content.
Lists the page number for the French language content.
Lists the page number for the German language content.
Read all safety precautions carefully for important information.
Guidelines for safe connection and use of the power supply to prevent electrocution.
Keep objects and liquids out of the product to avoid short circuits and damage.
Only authorized service centers should perform modifications or repairs.
Unplug the power cable if the product will not be used for an extended period.
Switch off and disconnect immediately if strange odors or smoke are emitted.
Connect only foreseen equipment and use approved rigging for suspension.
RCF recommends professional installers for safe and compliant system setup.
Ensure equipment is used only with manufacturer-recommended trolleys or supports.
Important mechanical and electrical factors must be considered during audio system installation.
Protect hearing from high sound levels by using adequate protection devices.
Place product away from heat sources with adequate air circulation.
Avoid overloading the product for extended periods to maintain performance.
Never force control elements like keys or knobs to prevent damage.
Do not use solvents, alcohol, or volatile substances for cleaning.
Describes the RCF ART series' technological advancements and sound revolution.
Details high power ferrite magnets and precision-built transducers for better performance.
Covers 400W digital amplifiers, SMPS power supply for high output and low weight.
Explains polypropylene composite cabinets, reflex porting, handles, and pole mount.
Accepts jack or XLR inputs for microphones/line sources; BALANCED INPUT/LINK.
Indicates amplifier limiter circuit status; blinks RED when active.
Lights green when there is signal present on the main input.
Green LED is ON when the speaker is connected and powered ON.
Provides a loop-through for daisy-chaining speakers to other units.
Adjusts amplifier volume; does not affect 'Link' output level.
Selects 'Flat' or 'Boost' equalization for background music applications.
Switch to LINE (0 dB) or MIC input for source level matching.
Connects the power cord to the unit for mains power.
Contains the mains fuse for protection.
Turns the AC power supply ON and OFF for the unit.
Details the AES standard pinout for XLR connectors (GND, HOT, COLD).
Connect cables, turn on mixer first, then speaker for safe operation.
Use 35mm socket for stands or approved rigging hardware for suspension.
Never suspend speakers by handles; use M10 inserts on opposite sides.
Microprocessor signals failures via Limiter LED flashing (Warning, Limitation, Failure).
Check connections, voltage, overheating; reset if Limiter LED remains on.
Fuse values for 230V/115V setups, for service centre use only.
Details frequency response, Max SPL, and coverage angles for each model.
Specifies low and high frequency transducer sizes and voice coil diameters.
Lists total, low section, and high section power for the amplifiers.
Specifies signal input/output and power input connectors used.
Describes equalization, crossover filtering, and limiter functions.
Provides dimensions (w, h, d), weight, and color for each model.
To Next Page