RCF ART 9 Series - Page 8

8
EN
1. H-BR - HORIZONTAL BRACKETS
On the bottom side screw the M10 bolt or knob (with its washers)
D
through the spacer�
Then screw the M6 bolt or knob (with its washers)
E
on an inclination hole (depending on the inclination needed)�
D
E
NOTE: once the speaker angle is defined, tighten strongly
the M10 knob or bolt
H
Place the horizontal bracket on the speaker; on the top side screw the M10 bolt or knob (with its washers)
H
through the bracket hole�
3
4
D
E