RCRCM Typhoon 2M User Manual

Typhoon 2M Instruction Manual
Typhoon is a CNC machine moulded, CAD designed slope model
aircraft. This plane has had a development period of over 2 years,
and four separate models to evolve into the highly agile thoroughbred
that you now own. We hope you have a lot of fun with it.
RCRCM Aeroteam, proud manufacturers.
Unpacking
• Please unpack the plane carefully making sure that you have
retrieved all of the small parts.
•
Don’t throw the box out until you are 100% sure it’s empty!
• Check that all the parts are supplied.
•
If any are missing please contact your vendor immediately.
Typhoon 2M parts
Before construction
• Start with a clean workbench and cover it with some foam, or a
soft thick cloth to protect the finish of the wings and fuselage as
you work.
• Be careful not to place the wings or fuselage on any screws or
tools etc that can dent or scratch the skin.

RCRCM Typhoon 2M Specifications

General

Brand	RCRCM
Model	Typhoon 2M
Category	Tools
Language	English

Summary

Unpacking

Before Construction

Wing Construction

Dry Assembly and Surface Movement Check

Perform dry assembly to check fit and ensure control surfaces have adequate movement, sanding hinges if needed.

Control Rod and Clevis Preparation

Prepare control rods and clevises, checking lengths and adjustability for smooth operation.

Servo Installation and Connection

Install servos, connect control rods, and verify alignment and secure connections for precise control.

Fuselage Construction

Rudder and Elevator Control Setup

Connect rudder and elevator control snakes/rods, checking for smooth, unimpeded movement.

Servo Tray and Pushrod Installation

Install the servo tray and connect rudder/elevator pushrods to servos, ensuring proper fit.

Wiring Harness and Battery Installation

Install the wiring harness, connect receiver and battery, and secure components for functionality.

Nose Weight and CG Balancing

Fit and secure nose weight, then balance the aircraft to achieve the correct Center of Gravity.

Control Surface Movements and CG Settings

General Control Surface Settings

Specifies recommended deflections for ailerons, flaperon, rudder, and elevator for optimal flight.

Crow Control Surface Settings

Details specific settings for crow configuration, including flap and aileron compensation for advanced control.

Thermal and Cruise Settings

Provides flap and aileron adjustments for thermal soaring and cruise flight modes to optimize performance.

Pacemaker Settings

Specifies reflex settings for ailerons and flaps to activate the 'Pacemaker' flight mode for enhanced responsiveness.