Flaps?
Crikey – they work too!
Now you might need the last bit:
Control surface movements and CG settings
C/G = 80 mm from Leading Edge to start. Move back slowly in
small increments to further improve control responses.
Control surface settings: (All measured from the outboard trailing edges)
GENERAL:
Ailerons = + 7 mm, -5 mm
Flaperon = +/- 8 mm
Rudder = As much as possible
Elevator = +/- 10 mm
CROW
Crow- Flap = As much as you can get.
Crow-Aileron = +7 mm
To Next Page
Loading...