•
Then simply cut the snakes to fit, remembering to leave space
for the adjustment clevis.
• Check for movement and adjust accordingly.
Done!
Installing the wiring harness
•
Use the RCRM wiring harness or make your own.
•
Check that the wiring harness connectors fit snugly into
the fuselage connector holes.
•
If not…file the holes out until they do.
• Thread the plugs through into the fuselage and rout the
receiver plugs to the receiver area.
•
Put in the receiver and battery temporarily and make sure
the whole shebang actually works!
• Now cyano the connectors into the holes.
Done! neat huh?
Battery installation
I made a couple of formers to keep the battery with holes in them
so that I could use tie wraps to keep it in one place. It gets really
boring when you are flying inverted and the battery ejects…
Nose weight (Note that the photos are for the Vector III but
exactly the same procedure applies.)
To Next Page
Loading...