RCS Technology TZ45R - Remote Sensor Configuration; RS1 and RS2 Sensor Settings; Restore Factory Defaults

DCN: 140-01773-03 Page 8
Remote Sensors
RS1 Type Specifies the thermistor sensor temperature curve type
Options: Curve A, Type 2, Type 3 Default: Type 3
RS2 Type Specifies the thermistor sensor temperature curve type
Options: Curve A, Type 2, Type 3 Default: Type 3
RS2 Location Selects RS2 installed location as indoor sensor or outdoor sensor
Options: IN (indoor) or OUT (outdoor) Default: IN
R1 Node ID Selects the node ID for a remote Z-Wave temp sensor to be used as RS1
Options: 0-252 Default: 0 (=not used)
R2 Node ID Selects the node ID for a remote Z-Wave temp sensor to be used as RS2
Options: 0-252 Default: 0 (=not used)
Restore Defaults Restores all settings to factory defaults.
Options: Yes, No Default: No
Press Yes to restore defaults,
Press No to exit and not restore defaults