To Next Page

To Previous Page

EPSILON ES2,ES4

IO Configuration of levels of fuel or temperature are shown in Pic. A 8.2

Pic. A8.2

Procedure of FLS "EPSILON" calibration

1) Start the program "eS Install" (see details in Appendix 1)

2) On the tab "Sensor’s general options" set following parameters of a measuring head:

 "Network address of device": 1

 "Repeat interval": 1

 "Capacity": 10 bit

 "Enable periodic output": activate

 "Enable text format": off

 "Exchange speed on UART: 19200

Pic. A8.3

Questions and Answers:

Need help?

Do you have a question about the RCS EPSILON ES4 and is the answer not in the manual?

RCS EPSILON ES4 Specifications

General