How to fix an RDM EC9000i Scanner printer that does not print?
If the printer on your RDM Scanner isn't printing, first check to ensure that the printer hasn't jammed. Also, make sure that the end of the paper roll unrolls from the top of the roll.
What to do if my RDM Scanner does not respond?
If your RDM Scanner isn't responding, first, check the cable connecting it to your computer. Make sure it's properly connected to the correct port on both the scanner and the computer, according to your distributor's instructions. Next, verify that the correct power cord is connected to the scanner. If necessary, try changing or replacing the power cord.
What to do if the RDM scanner does not respond?
If your RDM scanner isn't responding, first, check that the cable connecting it to your computer is correctly plugged into the appropriate port on both the scanner and the computer, following the distributor's instructions. Also, verify that the correct power cord is connected to the scanner; replace it if necessary.
What to do if card transactions do not function properly on RDM scanner?
If card transactions are not functioning properly on your RDM scanner, ensure that you are swiping the card correctly. Try using an alternative card to confirm that the initial card is not defective.
Why is the printer not printing on RDM scanner?
If the printer is not printing, ensure that the printer has not jammed. Also, make sure that the end of the paper rolls from the top of the roll.
General| Scan Speed | Up to 45 ppm / 90 ipm |
|---|---|
| Resolution | 600 dpi |
| Interface | USB 2.0, Ethernet |
| Feeder Capacity | 100 sheets |
| Scan Resolution | 600 dpi |
| Supported Document Sizes | Up to 8.5" x 14" |
To Next Page
