IMPORTANT: Point the nozzle at the
ground.
1. Check that the machine is in
upright position. NOTE: Do not
place the machine in high grass!
2. Release the trigger lock (12)
3. Activate the trigger of the trigger
gun (2) and let the water run until
all air has escaped from the water
hose.
4. Press the Start/stop switch (3).
5. Activate the trigger of the trigger
gun (2).
6. Always adjust the distance and thus
the pressure of the nozzle to the
surface, which is to be cleaned.
Do not cover the machine during
operation or use it in a room without
adequate ventilation!
NOTE: If the machine is left or not
used for 5 minutes, it must be
switched off on the start/stop switch
(5) "O":
1. Press the start/stop switch (3) "O".
2. Disconnect the electrical plug (7)
from the socket.
3. Shut off the water supply and
activate the trigger of the trigger
gun (2) to relieve the machine of
pressure.
4. Lock the trigger gun (2)
When releasing the trigger of the
trigger gun (2), the machine
automatically stops. The machine will
start again when you re- activate the
trigger gun (2)
The pressure can for the multi nozzle
(16) be adjusted by tuning it.
WARNING: Do not do this under
operation to avoid that the hand hits
the jet.
1. Unscrew the container (A) from the
foam sprayer
2. Add detergent to the container (A)
and screw the container to the
foam sprayer
3. Adjust the amount of detergent
with the button (B)
B
C
A
Pay special attention:
1, You can adjust the foam spray with
botton B, if you want spray water only,
you can turn botton B to close the
foam spray.
2, Foam equipped quick connector.
Press C, then insert into the gun.
Caution: When attaching the soap
bottle the button (C) should come out
again. Check before activating the
trigger that the nozzle is properly fixed.
3, Add detergent as following:
To Next Page
Loading...
