Why does my Reaim HPI-1100 have fluctuating pressure?
If you experience fluctuating pressure with your Reaim Pressure Washer, here's what might be happening and how to address it: * The pump may be sucking in air. Check all hoses and connections to ensure they are airtight. * The water supply may not be sufficient. Increase the water pressure, inspect the garden hose for any blockages, and consider switching to a larger hose.
Why won't my Reaim Pressure Washer start?
If your Reaim Pressure Washer refuses to start, there are several possible causes: * It might not be properly plugged in, so ensure it is connected to a functioning power outlet. * The socket you're using could be defective; try a different one. * A blown fuse could be the issue; replace the fuse and switch off other high-energy consuming devices on the same circuit. * A defective extension cable could be the culprit; try operating the machine without it.
Why is my Reaim HPI-1100 Pressure Washer pulsating?
If your Reaim Pressure Washer is pulsating, consider the following potential causes and solutions: * There might be air in the inlet hose or pump. Allow the machine to run with the trigger open until regular working pressure resumes. * The supply of mains water might be inadequate. Increase water pressure, check for blockages in the garden hose, and consider changing to a bigger hose. * The nozzle could be partially blocked. Clean the nozzle with a needle and spray water backwards through it. * The water filter might be blocked. Clean the filter. * The hose may be kinked. Straighten out the hose.
What to do if my Reaim HPI-1100 keeps stopping?
If your Reaim Pressure Washer stops unexpectedly, here are a few things to check: * A fuse may have blown. Replace the fuse and switch off other machines to reduce the load. * The mains voltage may be incorrect. Verify that the mains voltage matches the specification on the nameplate. * The thermal sensor might have activated. Allow the machine to cool down for 5 minutes. * The nozzle could be partially blocked. Clean the nozzle with a needle and spray water backwards through it.
How to fix a Reaim HPI-1100 Pressure Washer that starts but doesn't spray water?
If your Reaim Pressure Washer starts but no water comes out, here's what you should check: * The water filter might be blocked. Clean the filter. * The nozzle could be blocked. Clean the nozzle with a needle and spray water backwards through the nozzle.
Why does the fuse keep blowing on my Reaim Pressure Washer?
If the fuse blows in your Reaim Pressure Washer, it could be due to: * A fuse that is too small. Change to a fuse with a higher amperage rating than the machine's consumption. * An amperage increase. Try using the machine without an extension cable.
Why does my Reaim Pressure Washer start and stop by itself?
If your Reaim Pressure Washer often starts and stops by itself, it might be due to no water supply. Connect inlet water.
Details how to connect the garden hose to the pressure washer inlet.
General guidelines for using the pressure washer for various cleaning tasks.
General| Brand | Reaim |
|---|---|
| Model | HPI-1100 |
| Category | Pressure Washer |
| Language | English |
To Next Page
