OPERATION
1.
Turn your Amplifier/Receiver on.
2.
Turn your Audio p'ower Meter on.
3.
Set the range switch on the front
of
the Audio Power Meter
to
the desired
position either 2 or
200
watts.
4.
Now
you can read the actual output power
of
the peak
and
average level being
, delivered by the Amplifier/Receiver.
If
you notice distortion on peaks
of
music
power, your Amplifier/Receiver may
be
driving into the
"clipping"
area;
if
this
is
'the
case,
you may want
to
back
off
on the volume slightly. The
LED
PEAK
Indicators will show you
how
much power your Amplifier/Receiver will deliver
without
going into clipping distortion. The lit
LEDs
show the peak level
of
RMS
wattage being delivered at any given instant
of
time.
Note:
Meter Readings will
be
accurate only when you have a 4 or 8 ohms load
connected and the
Rear
Panel Switch
is
set
to
the correct position.
-5-
To Next Page
Loading...