Realtek RTL8710BN - FCC Radiation Exposure and Labeling; Antenna List

RTL8710BN
2017‐12‐2616

IMPORTANTNOTE:
FCCRadiationExposureStatement:
ThisequipmentcomplieswithFCCradiationexposurelimitssetforthforanuncontrolled
environment.Thisequipmentshouldbeinstalledandoperatedwithminimumdistance20cm
betweentheradiator&yourbody.

IEEE802.11bor802.11goperationofthisproductintheU.S.A.isfirmware‐limitedtochannels1
through13.

ThismoduleisintendedforOEMintegrator.TheOEMintegratorisresponsibleforthecompliance
toalltherulesthatapplytotheproductintowhichthiscertifiedRFmoduleisintegrated.
Additionaltestingandcertificationmaybenecessarywhenmultiplemodulesareused.


20cmminimumdistancehastobeabletobemaintainedbetweentheantenna andthe usersfor
thehostthismoduleisintegratedinto.Undersuchconfiguration,theFCCradiationexposurelimits
setforthforanpopulation/uncontrolledenvironmentcanbesatisfied.

USERSMANUALOFTHEENDPRODUCT:
Intheusersmanualoftheendproduct,theenduserhastobeinformedtokeepatleast20cm
separationwiththeantennawhilethisendproductisinstalledandoperated.Theenduserhasto
beinformedthattheFCCradio‐frequencyexposureguidelinesforanuncontrolledenvironment
canbesatisfied.Theenduserhastoalsobeinformedthatanychangesormodificationsnot
expresslyapprovedbythemanufacturercouldvoidtheuser'sauthoritytooperatethisequipment.
Ifthesizeoftheendproductissmallerthan8x10cm,thenadditionalFCCpart15.19statementis
requiredtobeavailableintheusersmanual:ThisdevicecomplieswithPart15ofFCCrules.
Operationissubjecttothefollowingtwoconditions:(1)thisdevicemaynotcauseharmful
interferenceand(2)thisdevicemustacceptanyinterferencereceived,includinginterferencethat
maycauseundesiredoperation.

LABELOFTHEENDPRODUCT:
Thefinal
endproductmustbelabeledinavisibleareawiththefollowing"ContainsTXFCCID:
TX2‐RTL8710BN".If the labelling area is larger than the palm of the hand, then the following
FCC part 15.19 statement has to also be available on the label: This device complies with
Part 15 of FCC rules. Operation is subject to the following two conditions: (1) this device
may not cause harmful interference and (2) this device must accept any interference
received, including interference that may cause undesired operation.
Antennalist:
Ant. Brand ModelName(P/N) AntennaType Connector Gain(dBi)
1 REALTEK Ameba‐AM0001 PrintedAntenna N/A 2.9
2 JOYMAX TWF‐614XMPXX‐500 DipoleAntenna I‐PEX 3.0
3 LYNwave ALA110‐222050‐300010 PIFAAntenna I‐PEX 3.5
Note:TheEUThasthreetypeantennas.