GPS Vehicle Tracker User Manual
Page 7
l 111111CHK
This instruction is used to inquiry the vehicle’s location & system’s status.
The system will send back the SMS, includes the similar information,
such as “Unit Disarmed……”
l 111111STP
This instruction is used to cut off the car’s power supply or fuel supply, so
as to stop the car.
The car will be controlled to stop gradually.
Attention: It is very dangerous to stop the car when the vehicle is running at high
speed. We do not take any responsibility to the consequence caused by this action.
l 111111STPN or 111111STP(N)
This instruction is used to stop the car under the condition of speed
limitation.
If the car is running at speed higher than N (KM/H), the instruction will not
be carried out. System will send back feedback SMS “No parking, vehicle …”;
If the car’s speed is less than the value N , it will be controlled to stopped
gradually.
Example: N =40. The car is running at speed of 50KM/H, user send 111111STP40
or 111111STP(40) to system, the system will send back SMS “No parking.” to warn user
that the condition is not met. Once the car’s speed is about 39KM/H, the system will
automatically carry out this instruction & stop the car.
The Minimum value of N is 30KM/H
l 111111RES
This instruction is used to restore the car to normal status after stopping
the car.
It is also used to stop the receiving of SOS alert SMS once the
anti-robbery SOS switch is pressed down.
l 111111MONP
This instruction is used to monitor the voice around the car. The SIM card
inside the system pays for the communication fee.
The P is the telephone which is used to monitor the voice. When user
send out this SMS to the system, the system will call back the telephone P,
To Next Page
Loading...