GPS Vehicle Tracker User Manual
Page 8
user could listen in the voice around the car upon picking up the call.
If you use the present mobile to carry out the monitoring, you can let the
P as blank, sending 111111MON is OK.
Example: P =13780012345. If user sends 111111MON13780012345 to system, the
system will call back the phone 13780012345 immediately. Once upon pickup the call
from the system, user can hear the voice around.
l 111111MON:Phone No.
This instruction is used to monitor the voice around the car. The user’s
telephone pays for the communication fee.
Example: User uses the telephone 38351400 to carry out monitoring and pay the
communication fee, user can send 111111MON:38351400 to the tracker firstly, then use
this phone 38351400 to call the tracker, it will be connected automatically to monitor the
voice. This setting is stored all the time until you change it to another phone no.
Remark: please do not set the user’s 1
st
alert-received phone no. as this phone no.
SOS Anti-robbery Alert
It is the optional function, it needs the optional component: SOS switch.
If you program the 1
st
& 2
nd
alert-received mobile only, once the SOS
switch is pressed down & hold for at least 3 seconds, the system will send
alarm SMS to the 1
st
& 2
nd
alert-received mobile. User can send command
111111RES to release it.
If you program the 3
rd
alert-received mobile as the center number, once
the SOS switch is pressed down & hold for at least 3 seconds, the system will
ONLY send alarm SMS to the center number. (the 3
rd
mobile no.). User can
send command 111111RES to release it.
Movement Alert
111111MOV0 to disable the movement alert
111111MOV1 to enable the movement alert, the present location is the
center.
111111MOV？ to check the center’s position.
Once the system is armed, the movement alert will be automatically
enabled. Once the system is disarmed, the movement alert will be
automatically disabled.
To Next Page
Loading...