REC ALPHA PURE - Page 22

-
REC Installation Manual - Module REC Alpha - IEC61215/IEC61730
Ref: PM-IM-23
REC Installation Manual - Module REC Alpha - IEC61215/IEC61730
Ref: PM-IM-23
Rev: . US
REC Installation Manual - Module REC Alpha - IEC/IEC
Ref: PM-IM-
Rev: . US
-
INSTALLATION OF REC ALPHA PURE  SERIES PANELS
0
0
11.4 in
15.75 in
20.9 in
22.25 mm
27.5 in
11.4 in
15.75 in
20.9 in
22.25 mm
27.5 in
7.9 in
0
0
0
0
7.9 in
11.8 in
11.8 in
7.9 in
11.8 in
11.8 in
7.9 in
2.5 in
2.5 in
0
0
290 mm
400 mm
530 mm
590 mm
700 mm
290 mm
400 mm
530 mm
590 mm
700 mm
100 mm
0
0
0
0
100 mm
250 mm
250 mm
100 mm
250 mm
250 mm
100 mm
90 mm
90 mm
Clearance Gap
. - . in
 -  mm
. - . in
 -  mm
>. in
> mm
Clamping Zone
Design Load
Test Load
Design Load
Test Load
Design Load
Test Load
LongSide
Mounting
. - . in
 -  mm
-
+ Pa / - Pa
+ Pa / - Pa
+ Pa / - Pa*
+ Pa / - Pa
. - . in
 -  mm
+ Pa / - Pa
+ Pa / - Pa
+ Pa / - Pa*
+ Pa / - Pa
+ Pa / - Pa*
+ Pa / - Pa
. - . in
 -  mm
+ Pa / - Pa
+ Pa / - Pa
+ Pa / - Pa*
+ Pa / - Pa
+ Pa / - Pa*
+ Pa / - Pa
. - . in
 -  mm
+ Pa / - Pa
+ Pa / - Pa
+ Pa / - Pa*
+ Pa / - Pa
+ Pa / - Pa*
+ Pa / - Pa
. - . in
 -  mm
+ Pa / - Pa*
+ Pa / - Pa
+ Pa / - Pa*
+ Pa / - Pa
+ Pa / - Pa*
+ Pa / - Pa
ShortSide
Mounting
. - . in
 -  mm
-
+ Pa / - Pa
+ Pa / - Pa
+ Pa / - Pa
+ Pa / - Pa
. - . in
 -  mm
-
+ Pa / - Pa
+ Pa / - Pa
+ Pa / - Pa*
+ Pa / - Pa
MOUNTING REC ALPHA PURE  SERIES PANELS WITH CONTINUOUS RAILS PARALLEL TO SHORT SIDE OF THE PANEL
A continuous rail (or other support structure) spans the complete underside of the panel
Clamping of REC Alpha Pure  Series panels with Rails parallel to the Short Side of the Panel
Rail positioning
Rail positioning
NOTE
Once a module is secured in each of the  zones , additional clamps, i.e., ≥, may be freely located on panel frame without affecting the
warranty. Loads marked with a * were not certified as part of IEC / testing; these have been evaluated by REC’s internal
testing process.
CAUTION
The center point of each clamp and the minimum grip length must be fully located in the same clamping zones to be rated to that load. If
the panel is secured in zones with diff erent load values, it is rated to the lowest load value only.
1
2
43
Fig. -