EasyManua.ls Logo

REC ALPHA PURE - Page 26

REC ALPHA PURE
38 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
-
REC Installation Manual - Module REC Alpha - IEC61215/IEC61730
Ref: PM-IM-23
REC Installation Manual - Module REC Alpha - IEC61215/IEC61730
Ref: PM-IM-23
Rev: . US
REC Installation Manual - Module REC Alpha - IEC/IEC
Ref: PM-IM-
Rev: . US
-
Clearance Gap
. - . in
 -  mm
. - . in
 -  mm
>. in
> mm
Clamping Zone
Design Load
Test Load
Design Load
Test Load
Design Load
Test Load
LongSide
Mounting
. - . in
 -  mm
- -
+ Pa / - Pa
+ Pa / - Pa
ShortSide
Mounting
. - . in
 -  mm
- -
+ Pa / - Pa
+ Pa / - Pa
LongSide
Mounting
. - . in
 -  mm
- -
+ Pa / - Pa
+ Pa / - Pa
ShortSide
Mounting
. - . in
 -  mm
- -
+ Pa / - Pa
+ Pa / - Pa
MIXED SIXPOINT MOUNTING FOR SHORT RAILS: REC ALPHA PURE 
A mixed six-point mounting configuration secures the panel on three short rails (or other support structures) with three clamps on each side of the
panel in the zones marked below:
Mixed Six-Point Mounting of REC Alpha Pure  Series Panels using short rails
Min.
2
5 m
m
Max
.
100 mm
Min.
1
00
mm
Max
.
200 mm
Rail length under module  -  mm
Rail length under module  -  mm
GR
907 mm
957 mm
0
0 mm
200 mm
0 mm
200 mm
200 mm
0 mm
200 mm
0 mm
GR
35.7 in.
37.7 in
.
0
0 in.
7.9 in.
0 mm
7.9 in.
7.9 in.
0 in.
7.9 in.
0 in.
NOTE
Once a module is secured in each of the  zones , additional clamps, i.e., ≥, may be freely located on panel frame without affecting the war-
ranty. Loads marked with a * were not certified as part of IEC / testing; these have been evaluated by REC’s internal testing pro-
cess.
CAUTION
The middle rail must not be installed on the side of the junction box where the cables exit.
A total of three continuous rails (or other support structures) must be used to secure the panel.
The center point of each clamp and the minimum grip length must be fully located within the marked zone to be rated to the given value.
1
2
43
Fig. -

Related product manuals