EasyManua.ls Logo

Reconyx HyperFire 2 Series - Page 32

Reconyx HyperFire 2 Series
36 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
31 RECONYX
®
, Inc.
Memory Card Problems
If your camera won’t start up properly or displays a card
error, write lock, first check to be sure your card is not
“Locked”. On most SD cards there is a switch on the side of
the card. If the card is locked, you will not be able to save
any photos. If the card is not locked, but this message
persists, you can attempt to clean the contacts in the card
holder by blowing canned air into the card slot. This will often resolve the issue.
If you have other issues, you may have to try a different brand of memory card.
We have found that some of the cheap memory cards are very slow and do not
always run well (even if they are advertised as fast). RECONYX
®
certified
memory cards are available at www.reconyx.com
Cold Weather Problems
If your camera shuts down in the cold, it may be too cold for the batteries. Refer
to Battery Specifications” for recommended battery types.
Extreme cold weather does have an adverse effect on the LCD display; this does
not inhibit the cameras ability to function; it just makes it hard to read the display.
Battery Life Less than Expected
NiMH batteries have decreased life in hot weather. They will run the camera, but
they will have decreased run time. It is not unusual to see battery life drop off
50% or more when daytime temperatures are near 90˚ Fahrenheit or higher. This
will not damage your NiMH batteries; their charge just runs down faster.
If you notice that nighttime illumination decreases over time, you should change
your batteries sooner, or switch to Lithium batteries.
Other Questions?
Please contact our Technical Support Department at 866-493-6064 or e-mail
at support@reconyx.com.

Related product manuals