8
Push down the stopper of the top cover to the
direction of arrow and lift up.
Turn the power switch & volume dial clockwise
to turn on.
volume dial
Turn the dial clockwise until it click to turn on.
Remove the pickup from the arm catcher and
place on the arm rest.
Remove the needle cover from the pickup.
Please pull it out
straight.
When downward pressure is applied to
needle, it may become loose or fall from
the main body and you hear only small
sound. Please refer to p8 [Replacement of
Record needle] to mount needle properly.
Adjust speed switch to rotation number of the
record.
This device does not support SP
record (78rpm).
Place a record on the turntable.
When playing LP, please use the adaptor for LP.
You can use this device putting obliquely. If you do
so, please insert supplied record holder to the
center spindle to fix the record. For detail, refer to
p10 [Use the device putting obliquely].
Lift the pickup and put the needle tip of the
pickup on the record softly.
When the pickup is lifted, the turntable starts to
rotate.
Turn the power switch & volume dial to the
desired sound volume.
After the end of playing, return the pickup to the
arm rest.
When you return the pickup to the arm rest, the
turntable stops.
When not playing the record, follow the
instructions below.
Turn the power switch & volume dial fully anti-
clockwise to turn off.
Return the needle cover to the pickup.
Return the pickup to the arm catcher.
Switch the speed switch to [OFF].
When not playing the record, DO NOT leave
the record holder attached to the center
spindle.
If the record slips while playing a film record,
please put the adapter for EP on the record.
When playing a film record, keep the device
a horizontal state.
To Next Page
Loading...