red lion IAMS 0001 - Setup and Function Key Operation; General Setup Procedure; Fast Setpoint Adjustment

17
SETUP /
OPERATING THE FUNCTION KEYS
Documentation for routing diagram.
In general:
When setting up the IAMS devices, you will be guided through all parameters
and you can choose the settings which fit the application. For each menu
there is a scrolling help text which is automatically shown in line 3 on the
display.
Setup is carried out by use of the 3 function keys:
1 will increase the numerical value or choose the next parameter
2 will decrease the numerical value or choose the previous parameter
3 will save the chosen value and proceed to the next menu
When setup is completed, the display will return to the default state 1.0.
Pressing and holding
3 will return to the previous menu or return to the default
state (1.0) without saving the changed values or parameters.
If no key is activated for 1 minute, the display will return to the default state
(1.0) without saving the changed values or parameters.
Further explanations:
Fast setpoint adjustment and relay test: These menus allow you to make a
quick setpoint change and relay test when the FastSet menu is activated.
This function can only be activated when the relays are set for setpoint
function and are controlled by a setpoint.
Pressing
1 and 2 simultaneously will activate a relay test and change the
state of the relay.
Pressing
3 will save the setpoint change.
Holding down
3 for more than 1 second will return the unit to the default state
without saving the setpoint change.