red lion Sixnet Series - Indicator Lights Overview

RAM 9000 Series Hardware Guide 5-22
Product Overview Revised 2015-07-16
Specifications
Indicator Lights
LED STATUS CORRESPONDING STATE
P1
ON Power is being applied to the primary input
OFF Power is not being applied to the primary input
P2
(Backup Power)
ON Power is being applied to the secondary input
OFF Power is not being applied to the secondary input
SD
ON SD Card mounted
OFF No SD Card mounted
GPS
ON Position fix available
OFF No position fix available
WAN
ON Cellular connection is established
OFF Cellular connection is not established
RSSI
Low Signal / No service
> - 109 dBm (Low but valid signal)
> - 99 dBm (Lower but valid signal)
> - 89 dBm (Avg signal)
> - 80 dBm (Excellent signal)
Reset
ON
Unit is booting. Not ready.
OFF
Unit is functioning normally
Status
ON
Unit is booting up.
OFF
Normal operation
FLASH
Unit entering reflashing mode. Do not disturb.
STROBE (Fast
Flash)
System error. Contact Red Lion Technical Support.
Ethernet Link and
Activity
(Yellow)
ON
Link detected
OFF
No link detected
FLASH
Linked and active communications detected
Ethernet Speed
(Green)
ON
100 Mbps link speed detected
OFF
10Mbps link speed detected
RS485
ON
Serial connection is configured for use
OFF
Serial connection is not configured for use
RS232
ON
Serial connection is established – with no data activity with host
OFF
Serial connection is not established
SLOW FLASH
Serial connection is established – with data activity with host
STROBE (Fast
Flash)
Unit is reflashing. Do not disconnect power!
RLY1
ON
The relay output is being activated. The Normally Open terminal
will be ON (closed). The Normally Closed terminal will be OFF
(open)
OFF
The relay output is not being activated. The Normally Open terminal
will be OFF (open). The Normally Closed terminal will be ON
(closed).