RAM 9000 Series Hardware Guide 5-24
Product Overview Revised 2015-07-16
Specifications
USB Device Port
This is a USB 2.0 Device interface on a Mini B connector. It offers Ethernet-over-USB RNDIS driver
connection with all major operating systems. Driver installation and detection should be auto-
matic on a properly configured Operating System.
USB Host Port
This is a USB 2.0 Host interface on a standard type A connector.
Specifications:
• USB Host USB 2.0 (1.5 / 12 / 480 MBit/s)
• Complies with Univ
ersal Serial Bus Specification Rev 2.0
• Har
dware over current protected (1.0 A max per port)
• Incr
eased Retention Connector (Complies with Class 1,. DIV II minimum withdrawal requirement of 15N)
• Not electric
ally isolated
• Only use shielded USB s
tandard cable
• Ma
ximum cable length: 5 m
Note: No software functions have been defined for this port yet. This functionality will be available in a future firmware
release.
Serial Port
The unit’s serial port is an RS232 DTE, compliant with EIA-232 standard. The connector used is DB9 male and is
shown in the illustration below.
Serial Connector (looking at front of unit)
To Next Page
Loading...