EasyManuals Logo

red lion T16 Product Manual

red lion T16
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
15
2

ANALOG OUTPUT RANGE (OPTIONAL)
1 V 2 mA
2 mA
Select the type of output and range. The Analog output jumpers are factory
set to current. They must be changed if voltage output is desired. The Analog
output can be calibrated to provide up to approximately 5% over range
operation (0 mA current can only go slightly negative).

ANALOG UPDATE TIME (OPTIONAL)
to 2 seconds
= update rate of 0.1 second
The update time of the Analog Output can be used to reduce excess valve
actuator or pen recorder activity.

ACCESS CODE
12 to 12
I

I

I
I
I

The following parameters can be configured for , I, and I.


I


nF
I



The following parameters can be configured for  or I only.


ANALOG OUTPUT ASSIGNMENT (OPTIONAL)
This setting selects the parameter that the Analog Output will retransmit or
track.
ANALOG LOW SCALING (OPTIONAL)
-999 to 9999
The Analog Output assignment value that corresponds to 0 V, 0 mA or 4 mA
output as selected.
ANALOG HIGH SCALING (OPTIONAL)
-999 to 9999
The Analog Output assignment value that corresponds to 10 V or 20 mA
output as selected. An inverse acting output can be achieved by reversing the
low and high scaling points.
7.3 module 3 - loCKout pArAmeterS (3-LC)




 
SETPOINT
ACCESS
OUTPUT
POWER
PID
VALUES
SETPOINT
SELECT

ACCESS
CODE
ACCESS ACCESS
VALUES
ALARM
ACCESSACCESS


 


SETPOINT
RAMP
ACCESS
CONTROL
TRANSFER
ACCESS
AUTO-TUNE
START
ACCESS
RESET
ALARMS
ACCESS
PARAMETER MENU


1
I

In

Active Setpoint
SETPOINT
ACCESS
OUTPUT
POWER
ACCESS
PID VALUES
ACCESS
ALARM
VALUES
ACCESS
SETPOINT
SELECT
ACCESS
AUTO-TUNE
START
ACCESS
SETPOINT
RAMP
ACCESS
CONTROL
TRANSFER
ACCESS
RESET
ALARMS
ACCESS
Input Signal Retransmission
Main Control % Output Power
SELECTION DESCRIPTION
I
Display: accessible in Display Loop.
I
Hide: accessible in Hidden Loop.

Locked: not accessible in either loop.
 (SP only)
Display/read: read only in Display Loop,
but read/write in Hidden Loop.
Full access to Display, Hidden,
and Configuration Loops
1 to
12
Code necessary to access
Configuration Loop only.
1 to 12
Code necessary to access
Hidden and Configuration Loops.

Other manuals for red lion T16

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the red lion T16 and is the answer not in the manual?

red lion T16 Specifications

General IconGeneral
Brandred lion
ModelT16
CategoryController
LanguageEnglish

Related product manuals