Operation:
In operation, it's highly recommended to enable CTCSS for the channel you're using to
prevent the repeater from detecting and repeating unwanted signals from other radio
operators. The SRPT-02 will record and repeat any signal heard on the channel under
normal operation.
It is also recommended to disable voice prompts on the radio when using the UV-5R.
Failing to do so will result in the radio recording and replaying “Frequency Mode” when
the radio is first powered on.
Normal operation:
Once the radio and the SRPT-02 are connected and powered on, you are ready to use
it. Adjust the volume on the radio to approximately 50% of the full range. You may need
to make further adjustments based on the specific model of the two-way radio you're
using.
Once the radio detects a carrier signal, the SRPT-02 will begin recording voice
transmissions from the airwaves. It will continue until the carrier signal is lost or until a
maximum recording time of 10 seconds is reached. After the carrier signal is lost, the
repeater will pause and key up the radio to start transmitting the recorded voice.
Additionally, if Station ID is enabled, it will be transmitted in Morse Code after the voice
transmission is complete.
To Next Page
Loading...