Enable/Disable Repeater:
You can enable or disable the repeater in the field using DTMF detection by keying up
your radio and pressing "#" to disable the repeater or "*" to enable it during your
transmission.
#=”Disable Repeater”
*=”Enable Repeater”
When the repeater has been disabled, the repeater will acknowledge with three
slow beeps.
When the repeater has been enabled, the repeater will acknowledge with three
fast beeps.
Configuration:
The SRPT-02 features a web interface for system configuration and firmware
upgrades. It can be accessed via a standard web browser on your phone or PC over
Wi-Fi. The web interface is disabled during normal operation for power-saving and
security reasons.
Setup:
Follow these steps to access the web interface and configure your SRPT-02
repeater:
1. With the SRPT-02 powered on, press the "Setup" button on the front of
the repeater. In Setup mode, "PWR," "REC," "PLAY," and "TX" LEDs will
be illuminated. In this mode, the SRPT-02 acts as a wireless hotspot for
configuration.
2. In your wireless settings, select the access point labeled "SRPT-02" see
figure 3.1.
3. Once connected (no authentication required), a web browser page should
open see figure 3.2.
4. Older phones will require you to enter the URL into your Web browser this
is: http://192.168.244.1
To Next Page
Loading...