Deep Sleep Mode:
The repeater may be operated in deep sleep mode for further reduced
power consumption. Please note that when operating in this mode, there
is a 1.5 second delay that is needed for the repeater to wake from deep
sleep mode once a carrier has been detected. With this feature enabled,
the front panel LED’s will not be operational. Powering the repeater on in
this mode will be indicated by the Power LED flashing twice. Powering off
will be indicated by a single flash.
Enable Debug Mode:
This is used for debugging purposes and should only be enabled when
instructed to do so by a qualified engineer or software developer. Debug
messages can be monitored using a standard USB cable connected to a PC.
Firmware Update:
From time to time, it may be necessary to perform a firmware update for the SRPT-02
repeater. Here's how to do it:
1. Obtain a firmware image from Red's Engineering, which will typically be in
a compressed .zip file format.
2. Decompress the zip file to obtain a .txt file (release notes) and the image
file with a .bin extension.
3. Power on the SRPT-02 and place it in configuration mode by pressing the
Setup button. In this mode, the "PWR," "REC," "PLAY," and "TX" LEDs
will be illuminated.
4. In your wireless settings, select the access point labeled "SRPT-02."
5. Once connected (no authentication required), a web browser page should
open with the main SRPT-02 configuration screen. See figure 3.2
6. Click on the Menu Icon, then select "Upgrade".
7. Note the current firmware revision running on the repeater See figure 3.4
8. Click "Choose File" and select the .bin file provided by Red's Engineering.
9. Press the "Update" button and wait for approximately 30 seconds. The
repeater will reboot and be ready for normal operation.
10. It's recommended to enter setup again and verify the new firmware
version.
To Next Page
Loading...