LOADING THE PELLETS
Fuel is loaded from the upper part of the stove by lifting the cover. Slowly pour the pellets into the hopper.
For correct stove operation the pellet loading cover in the tank must be closed. Ensure the gasket “Z” of the cover
correctly rests on the tank and that there are no foreign bodies that prevent hermetic closure.
The stove does not load pellets if the loading cover is open.
Never remove the protection grid inside the hopper. When loading, do not let the pellet bag come into contact with
hot surfaces.
No other type of fuel other than pellets is to be inserted into the hopper, in compliance with above-mentioned
specications.
Store the spare fuel at an adequate safe distance.
Do not pour pellets directly onto the brazier but only into the hopper.
Most of the stove surfaces are very hot (door, handle, glass, smoke outlet pipes, hopper door etc.), therefore it is
recommended to avoid coming into contact with these parts without appropriate protective clothing.
To Next Page
Loading...
