START-UP
Press key 1 (esc) to begin start-up, the control panel displays ON with a ashing ame. When the ame stops ashing the boiler has
reached the “power output” operating mode.
The room temperature set by default is 20°C, if one wishes to change it act as instructed in the adjustments menu; act likewise to set the
heating water temperature and the room fan speed (if envisaged). To activate external thermostat if any see the relative section.
POWER OUTPUT
Once the start-up stage is complete the control panel will display ON with a xed ame at level 3 . The subsequent ame modulation
at lower or higher powers is managed autonomously and upon reaching the temperatures set in the “System conguration”.
To Next Page
Loading...
