30
3 USER GUIDE
The MaxCharge Current setting refers to the amount of current permitted by The
Manager30 to charge the battery, up to a maximum of 30 Amps.
Set Charging Current Screen R-Bus Diagnostics Screen
Advanced Settings Screen
Low SoC Alarm Screen
If the Charging Current setting is set lower than 30 Amps the excess current will
be used to supply the loads running from the battery under charge.
Confirm Setting Increase Charging Current
Cancel Setting
Decrease Charging Current
The Low SoC Alarm setting will sound an alarm when the battery State-of-Charge
reaches a particular setting.
Set Alarm SoC Screen MaxCharge Current Screen
Advanced Settings Screen
Low Voltage Alarm Screen
The Set Alarm SoC setting sets the percentage of State-of-Charge at which the
alarm will sound. The Alarm SoC can be set to from 0 – 100%.
Confirm Setting Increase Alarm SoC
Cancel Setting Decrease Alarm SoC
The Low Voltage Alarm setting will sound an alarm when the battery Voltage reaches
a particular setting.
Set Alarm Voltage Screen Low SoC Alarm Screen
Advanced Settings Screen Load Disconnect Screen
The Set Alarm Voltage setting sets the Voltage at which the alarm will sound. The
Alarm Voltage can be set to OFF.
Confirm Setting Increase Alarm Voltage
Cancel Setting Decrease Alarm Voltage
NOTICE
It is recommended to set the SoC or Voltage Alarm level above the Load Disconnect Turn OFF level and
below the Turn ON level. This will ensure that, in the event the loads have been disconnected, when
reconnection occurs the Alarm does not sound.
To Next Page
Loading...
Need help?
General
