Redarc GoBlock PPS12050 - Page 14

14 | Charge the GoBlock
Charge From a Vehicle Accessory Socket
Plug the supplied 7.5A Accessory Socket Trickle-Charger into a vehicle accessory socket in your
vehicle, then plug the charger into the Trickle-Charge Input on the GoBlock.
The GoBlock will charge at a maximum rate of 7.5A, however this may be less depending on the
voltage of the vehicle.
IMPORTANT: When charging via the 7.5A Accessory Socket Trickle-Charger, the GoBlock may
completely discharge your vehicle battery in the following cases:
 If the vehicle accessory socket is connected directly to the vehicle start battery; i.e. the socket is
powered even when the vehicle ignition is off)
 When the ignition is in the 'ACC' position; e.g. listening to music while the engine is not running.
Ideally, only charge via the vehicle accessory socket when the engine is running.
CAUTION
 When charging the GoBlock from a vehicle accessory socket, ensure that the Trickle-Charger
accessory connector is fully inserted into the accessory socket in the vehicle. Poor contact
can cause the plug to overheat.
 The Accessory Socket and Trickle-Charger connector may become hot during
normal use — take care when handling.
Charging from a vehicle accessory socket using the Trickle-Charger.
CONTENTS