1
WARNINGS & SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS - THIS MANUAL CONTAINS IMPORTANT SAFETY
INSTRUCTIONS FOR THE
TOW-PRO
®
ELITE
BRAKE CONTROLLER.
DO NOT OPERATE THE CONTROLLER UNLESS YOU HAVE READ AND UNDERSTOOD
THIS MANUAL AND THE CONTROLLER IS INSTALLED AS PER THESE INSTALLATION
INSTRUCTIONS.
ENSURE THAT YOUR TRAILER BRAKES ARE INSTALLED AND ARE OPERATING CORRECTLY:
IMPROPERLY INSTALLED AND/OR FAULTY TRAILER BRAKES CAN CAUSE ERRATIC
VEHICLE OR TRAILER BEHAVIOUR WITH THE POTENTIAL TO CAUSE A ROAD ACCIDENT.
FOR THIS REASON, IT IS OF UTMOST IMPORTANCE THAT YOUR TRAILER BRAKING
SYSTEM BE INSTALLED/MAINTAINED BY A QUALIFIED INSTALLER.
ALWAYS CHECK BRAKES AT LOW SPEED EACH TIME A TRAILER IS ATTACHED TO YOUR
VEHICLE.
1. Ensure that the Tow-Pro
®
Elite is mounted securely in a fixed location. Failure to mount securely
will result in inaccurate braking force measurements and incorrect braking of the trailer.
2. Ensure that the Tow-Pro
®
Elite is installed inside the vehicle cabin and away from any
environmental conditions that may cause damage, including engine heat, submersion in water,
salt spray and humidity. Exposure to these conditions may cause damage to the unit’s circuitry
and may cause erratic trailer braking.
3. A Fuse or Circuit Breaker of appropriate rating must be installed to protect the vehicle system.
Please refer to the installation instructions starting on Page 7 for specific instructions on where
to install the Fuse or Circuit Breaker and for appropriate Fuse or Circuit Breaker rating. The Fuse
or Circuit Breaker must be installed as close as possible to the battery.
TOW-PRO
®
ELITE (EBRH-ACCV3-NA) TRAILER BRAKE CONTROLLER
The Tow-Pro
®
Elite is an electric trailer brake controller designed to suit most common
trailer braking applications whilst requiring minimal dash space and being simple to
install and operate.
The Tow-Pro
®
Elite offers selectable Proportional or User Controlled trailer braking
modes allowing the user to choose the braking style depending on the road or terrain
conditions, vehicle type, or driver preference.
The Tow-Pro
®
Elite features Active Calibration which constantly monitors the direction
of travel and will even calibrate with no trailer attached whilst maintaining the ability to
mount in any orientation.
The unit is able to operate electric trailer brakes from either 12V or 24V vehicle
systems without the need for manual selection or extra components/ wiring.
The unit is able to operate Electric / Hydraulic trailer brakes from 12V vehicle systems.
EBRH-ACCV3-NA Instruction Manual – Version 1
To Next Page
Loading...
