Redarc Tow-Pro Elite - Wiring Diagrams - Electric Brakes

8
2 INSTALLATION
2.2.2 Wiring Diagrams - Electric Brakes
For 12V and 24V vehicle electrical systems, the Tow-Pro
®
Elite is designed to operate
electric brakes without the need for any additional converters. For wire selection refer
to the wiring gauge guide in Section 6.
To 12V Vehicle
Brake Light trigger
(refer to Section 2.2.1)
To 12V Electric
Trailer Brakes
Blue
Red
25A Fuse or
30A Circuit Breaker
(CBK30-EB)
12V Vehicle
Start Battery
Ground
Black
-
Dash mount
controls for
Tow-pro.
White
14AWG (1.25mm²)
12AWG (3.0mm²)12AWG (3.0mm²)
14AWG (1.25mm²)
Ground
12V
24V
INPUT
To 24V Vehicle
Brake Light trigger
(refer to Section 2.2.1)
To 12V Electric
Trailer Brakes
Blue
Red
25A Fuse or
30A Circuit Breaker
(CBK30-EB)
24V Vehicle
Start Battery
Ground
White
Black
-
Dash mount
controls for
Tow-pro.
Ground
14AWG (1.25mm²)
12AWG (3.0mm²)12AWG (3.0mm²)
14AWG (1.25mm²)
The Input Power (Black) wire must be connected directly to the positive terminal
of the start battery via a Fuse (25A) or Circuit Breaker (30A) and not through
an Ignition source.