R3C Radio Guide
Beginner Mode
Beginner mode is designed for people who are new to the hobby.
In this mode, throttle output is limited to 50 percent and the channel range by default is set to 1250~1500~1750us.
Setup:
To switch between beginner mode and normal mode, press and hold the CH4 button while turning the steering
wheel counterclockwise as far as it will go. While holding, power on the transmitter. The G.LED will flash in a
sequence of “flash-flash-off, flash-flash-off”, indicating beginner mode is activated.
Note: By default, the system is set to normal mode each time it is turned on .
Low Voltage Protection & Overheating Protection
This receiver has a low voltage protection function.
• Low Voltage Protection: When the battery voltage is detected to be lower than the safe operating range,
power output to all channels will be cutoff.
This receiver/ESC also has an overheat protection function that will cutoff power to CH2 when activated. Once
the receiver/ESC cools down to normal operating temperature, CH2 will resume to it’s normal operating power
output.
Note: In the event there is a blockage in the drive train, the receiver/ESC will cutoff power to the motor (CH2)
to prevent damage to both the receiver/ESC unit and the motor. If this happens, inspect the vehicle and clear
out anything that may be obstructing the drive-train from spinning freely. This may include lodged sticks, rocks,
or anything else binding the drive-train.
TM
9
To Next Page
