REDCAT ASCENT FUSION - Gear Installation and Case Reassembly

TM
12
12. Slide the new upper gear onto the upper
idler shaft. (Will be either 20T, 19T, or 18T
depending on choice) (18T is pictured)
13. Realign the rear case and gently push it
into place. (you may need to rotate the idler
shaft slightly to line up the gears)
14. Reinstall the two screws. The longer screw
goes into the driver’s side of the case and the
shorter screw goes into the passenger’s side.
15. Reattach the driveshaft and reinstall the
driveshaft screw.
16. Reconnect the rear shock.
CHANGING THE UNDERDRIVE GEARS - EVEREST ASCENT & ASCENT FUSION
LONG
SHORTSHORT