RD-2-7783 (REV. A) Page 1 SUBJECT TO CHANGE WITHOUT NOTICE
E-6100
Rooftop Air Conditioner
MODEL E-6100 ROOFTOP AIR CONDITIONER INSTALLATION INSTRUCTIONS
NOTE:
1. Please read instructions all the way through before beginning work. Not following these instructions may result in
voided warranty.
2. Check that all items called out on the RD-2-7784-0 accessory kit list have been included.
3. It is critical that minimum 4GA cable be used for the compressor power/ground runs. Direct connection to battery or
nearby terminal blocks is recommended. Maximum 26 foot runs allowable for 4GA cable. Using larger wire is
acceptable, but voltage drop must be considered. Using cables smaller than 4GA may result in voided warranty
and/or damage to vehicle.
A. Mounting The Unit On Cab Roof
Note:
a. To maintain proper oil circulation and condensate drainage, unit must be mounted within the maximum tilt angles
shown here (exceeding these angles may result in compressor damage and/or voided warranty):
INSTALLATION INSTRUCTIONS
Do not mount the unit with the
front lower than the rear, as this
will prohibit water drainage.
To Next Page
Need help?
General
