15
Crankshaft problems
Big end nuts slacken
Solve vibration, see vibration.
Crankshaft bearing collapsed.
Incorrect assembled after repair.
Remove, clean, use loctite
Rear roller shacking
Rear roller locked
Rear roller up with hollow coring
Tough circumstances
Unlock.
Change speed and PTO rev’s.
Put roller free on the ground.
Change machine settings..
13.0 MAINTENANCE.
Pre-Delivery-Inspection
Check bolts/ nuts
Connect the unit to a tractor
Run unit for 5 min
See instructions in this manual.
Look and listen.
After first 20 hours
(new or repaired)
Grease PTO and rollers
Check bolts/nuts
Look closely at machine
4 shots each EP 2.
After every 100 hours
Grease PTO and rollers
Check bolts/ nuts
Look closely at machine
Grease spindles front roller
4 shots each EP 2.
14.0 EU-Declaration
.
We, Redexim Utrechtseweg 127 3702 AC Zeist Holland, hereby declare fully on our authority that
the product:
VERTI-DRAIN 7113, WITH MACHINE NUMBER AS INDICATED ON THE MACHINE AND
IN THIS MANUAL,
to which this declaration applies, has been manufactured in line with NEN-EN-ISO 12100-1,
NEN-ISO 12100-2 and NEN-EN 294, according to the stipulations of: The Machine Directive
98/37/EG.
A.C. Bos
Manager Operatios and Logistics
Redeiem Holland
To Next Page
Loading...
