IR LED: Auto/ Economy/ Off
•
Set the infrared LEDs brightness.
•
PIR Interval: Defaulted 30seconds, optional from 5seconds ~60minutes
Select the shorsetup period for the camera to wait before it reacts to the
successive triggering of the main sensor after an animal has first been
detected. The camera does not record any images or videos during the
selected interval. This prevents the memory card from being filled with
unnecessary shots.
•
Mode : Photo
•
PIR Sensitivity: High/ Medium/ Low
, Video, Photo + Video
Select whether photos or videos should be taken when motion is detected.
When in the"Photo + Video" mode, the camera first takes a set number of
photos prior to recording a video.
Note:
•
The interval time is short, the camera shooting frequency would be high,
and there would be high consumption of batteries. It would effect the
usage days of the batteries. It is just on the opposite ,the interval time is
long, would be a lower consumption of batteries to guarantee a long
time usage.
Time lapse: Off/On
When “on” has been selected, the camera would automatically takes
photos/ videos in the selected time interval, irrespective of whether or not
the PIR sensor has detected a motion or not. This is useful for observing
cold blooded animals e.g. snakes or plants opening up, etc.
As soon as the "On" setting has been confirmed by pressing the OK button,
you can enter the interval time after which photos/ videos are to be taken.
Note:
In this mode, the PIR function would stop working, and the camera
would take photos/ videos in the setting interval time.
•
•
To Next Page
Loading...