To start the product
1. Set the throttle to the position for idle speed.
2. Push the air purge bulb again and again until fuel
starts to fill the air purge bulb. It is not necessary
to fill the air purge bulb fully.
3. Push the start button down fully until it locks in
position.
Note:
If the throttle is not set to idle speed, the
start button does not lock in position.
4. Put the product on a flat surface on the ground.
5. Hold the product with the left hand and put one
foot on the foot plate.
6. Pull the starter rope handle slowly until
resistance occurs.
7. Pull the starter rope handle quickly with the right
hand until the engine starts.
Note: Do not pull the starter rope handle to full
extension and do not let go of the starter rope
handle.
8. Let the engine run for 2–3 minutes to become
warm before operation.
To stop the product
CAUTION: Stop the product when
the engine is at idle speed.
• Push the stop switch.
Maintenance
Introduction
WARNING: Read and understand
the safety chapter before you do
maintenance on the product.
Maintenance schedule
Maintenance Daily Weekly Monthly
Clean the external surfaces. X
Make sure that the control handle operates correctly. X
14 2318 - 002 - 17.11.2023
To Next Page
Loading...
