Charging your vacuum cleaner Empty the dust container &dust filter
Charging your vacuum cleaner
1.Place the machine near to the power supply ,make sure that the vacuum does
not shake.
2.Connect the machine to the adaptor and plug it into the power supply.
3.When the lamp lights up,the vacuum cleaner starts charging.
4.The color of the lamp shows different according to the remaining power.
5,When the vacuum cleaner is fully charged ,the light goes out.
Empty the dust container &dust filter
Note:Press the button of the dust cup to empty
the container.
Clean the dust container &dust filter
Note:In order to ensure the good cleaning
efficiency of the vacuum cleaner ,Please clean the
dust cup and filter after five times of usage.
1.Remove the dust cup from the vacuum cleaner.
2.Press the button of the dust cup .Take down the
dust cup as shown in the picture.
3. Take out the HEPA from the HEPA cover and wash the HEPA filter and HEPA cover
with cold water.Install them on the vacuum cleaner when they are completely dry.
Do not dry with a hair dryer.
The wall charger base assemble
As show in the picture
06 07
To Next Page
Loading...
