Fusion TREADMILL
20
ASSEMBLY INSTRUCTIONS
STEP 3:
NOTE: You will need to raise the base frame (701), and please make sure it locks so as not fall during
assembly ..
Attach the Upright Lower Cover -LL (305) and Upright Lower Cover -LR (306) to Upright –Left (301), and
Secure with Four 3.5 x 16 mm screw (802) as drawing shown.
Attach the Upright Lower Cover -RL (307) and Upright Lower Cover- RR (308) to Upright-Right (302), and
Secure with four 3.5x16mm screw (802) as drawing shown .
To Next Page
Loading...
