Reebok RX 820 User Manual (English)

Questions and Answers:

C
Cody SalazarAug 12, 2025
What to do if my Reebok Treadmill power turns off during use?
- K
  Kristin MurrayAug 12, 2025
  If your Reebok Treadmill's power turns off during use, first check the circuit breaker located near the power cord. If it has tripped, wait five minutes, then press the switch back in. Also, ensure the power cord is securely plugged in; if it is, unplug it, wait five minutes, and plug it back in. Additionally, remove and reinsert the key fully into the console, and verify that the on/off switch is in the 'on' position.
A
aaronkellerAug 18, 2025
How to fix a Reebok RX 820 Treadmill that does not turn on?
- R
  Roberto BarreraAug 18, 2025
  To troubleshoot a Reebok Treadmill that won't turn on, ensure the power cord is plugged into a surge suppressor and that the surge suppressor is plugged into a grounded outlet. Also, make sure the safety key is fully inserted into the console. Check the circuit breaker near the power cord; if it's tripped (switch protrudes), wait five minutes, then press the switch back in to reset it. Finally, confirm that the on/off switch near the power cord is in the 'on' position.
E
Eric MacdonaldAug 25, 2025
What to do if Reebok Treadmill walking belt is off-center or slips?
- R
  Robert RobbinsAug 25, 2025
  To correct an off-center or slipping walking belt on your Reebok Treadmill, first remove the key and unplug the power cord. If the belt is off-center to the left, turn the left rear roller bolt clockwise 1/2 turn; if it's off-center to the right, turn the bolt counterclockwise 1/2 turn. If the belt slips, turn both rear roller bolts clockwise 1/4 of a turn. Ensure you don't overtighten the belt—you should be able to lift each side 3 to 4 inches off the platform. Plug in the power cord, insert the key, and walk on the treadmill carefully for a few minutes.
H
hillpatrickAug 29, 2025
Why does the Reebok RX 820 walking belt slows when walked on?
- C
  chelsearamosAug 30, 2025
  If your Reebok Treadmill walking belt slows down when you walk on it, use only a single-outlet surge suppressor. If the belt is overtightened, remove the key and unplug the power cord. Use an allen wrench to turn both rear roller adjustment bolts counterclockwise 1/4 of a turn. The belt should be tight enough that you can lift each side 3 to 4 inches off the walking platform. Plug the cord back in, insert the key, and run the treadmill for a few minutes.
E
Elizabeth PerezSep 4, 2025
How to recalibrate the incline on a Reebok RX 820?
- D
  derekmartinSep 4, 2025
  To recalibrate the incline on your Reebok Treadmill, insert the key into the console and press one of the Incline buttons. While the incline is changing, remove the key. After a few seconds, re-insert the key. The treadmill will automatically rise to the maximum incline level and then return to the minimum level.